Allied Vision Technologies GC1290 Spezifikationen PDF herunterladen (Seite 19)

GC1290 Technical Manual Page 15

Installing GigE Viewer for Testing

o The latest Viewer software can be downloaded from

http://www.alliedvisiontec.com/us/support.html

o Run the GigE Viewer Installer.exe. This will install the Prosilica GC Digital Camera drivers as

well as the GigE Viewer application program.

o Plug in the Prosilica GC camera via the Gigabit Ethernet port. Plug in the power connection.

Verify that the Status LED 2 is a solid green. Run the GigE Viewer Application. It will take a few

seconds for the camera to be recognized. If the camera does not appear in the Viewer list after

approximately 10 seconds then try disconnecting and reconnecting the power. If it still does

not appear restart the viewer. If it still does not appear, see the Trouble Shooting section of

this document.

o See Figure 8. Select the wrench icon to change camera settings. Change the PacketSize to a

value of 1500. Select the eye icon to image. The camera should now be imaging. If the

camera is not imaging, see the Trouble Shooting section of this document. Note that the

PacketSize can be set to 8228 if the network card has been optimized to support jumbo frames.

o See the System Optimization Section to maximize the performance of your system.

Figure 8. GigE Viewer application window.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Keine Kommentare

Allied Vision Technologies GC1290 Spezifikationen Seite 19